3D Printed Musical Instrument--Classic Guitar
Electric Guitar by DarrenN2 (published at Raise3D forum)
Printer: Raise3D N2
Model from: http://www.thingiverse.com/thing:710561
Filament used was a Wood filament from Filaments.ca in Canada
Settings: 0.27mm layer height and 30% infill. Print temp of 205℃ and bed temp of 60℃
Total of 12 printed parts
Total print time of approximately 88 hours
The print quality is superior so it needs minimum surface finish.
Printer: Raise3D N2
Model from: http://www.thingiverse.com/thing:710561
Filament used was a Wood filament from Filaments.ca in Canada
Settings: 0.27mm layer height and 30% infill. Print temp of 205℃ and bed temp of 60℃
Total of 12 printed parts
Total print time of approximately 88 hours
The print quality is superior so it needs minimum surface finish.
Do you know which is printed and which is bought?
Ta-Da！
