Raise-Wiki-Printing Defects
Now you have successfully started your print job. But printing defects exsist, please check the topic below to check your problems. Most of them related to slicing setting, filaments, print bed setup. So please be patient. You are getting more closer to a good print!
Not Extruding at Start of a Print
Print Not Sticking to the Bed
Extruding too Little / Much Plastic
Holes and Gaps in Floor Corners
Holes and Gaps in Solid Layers
Stringing or Oozing
Overheating
Inconsistent Extrusion
Vey Small Features Not Being Printed
Blobs and Zits
Weak Infill
Stops Extruding in the Middle of a Print
Clogged Extruder
Grinding Filament
Layer Separation and Splitting
Battery Problem
Strange Noise when Homing